Settings

Converting Bores to Pockets in SmartWOP

160 views September 10, 2018 lars 1

There may be cases where you don’t want to drill a hole in your panels but rather treat them as a small pockets and have them milled.

In order to do this within SmartWOP follow this short guide.

 

Go to File>Options>Workshop here you can find the new settings in the lower right corner.

Now you need to enter the drill diameter in mm followed by => and the Tool Number you want to use for your pocket.

Example: 10=>201;12=>201

After you have saved your settings, restart SmartWOP and the diameters you have entered will now be treated as pockets.

 

Enjoy construction with SmartWOP!

 

Was this helpful?

Leave A Comment

*
*